Page 1 of 1

If syntax Interface.InBitRate

Posted: Thu Mar 15, 2012 9:59 am
by Duduhandelman
Hi All,
Sometimes I would like to add a condition to a Link label. I would like to write a text in the label when the Interface.InBitRate = 0.
The reason for that is that when having an Ethernet circuit that cross other equipment in the way. it will not show as down if the circuit is connect to the next hop but disconnected after that.
But if the Rx =0 there is a good chance that something is wrong.

Is there any way to do that?
I'm able to do that with SNMP but it will be nightmare to configure every link.

Many Thanks.

Re: If syntax Interface.InBitRate

Posted: Thu Mar 15, 2012 3:15 pm
by lebowski
I don't think there is an easy way but this is along the lines of what you are looking for. http://forum.mikrotik.com/viewtopic.php ... nk#p218076