Community discussions

MikroTik App
 
User avatar
tevolo
Member Candidate
Member Candidate
Topic Author
Posts: 114
Joined: Sun Mar 29, 2009 8:39 pm

Bandwidth Monitor for Queue Tree

Mon Apr 23, 2012 5:48 pm

I've been trying to setup a chart to monitor bandwidth usage for each Queue Tree we have, and I finally was able to create this by finding the correct OID using SNMPWalk.
Once I added the Data Source for each OID, I noticed the data it was charting was incorrect. Using a Scale of 1, showed the data but it was far too low compared to my interface charts. I then checked the Data Source for an Interface that I'm charting, and noticed it uses a Scale of 8. Once I changed the Scale to 8 for the Queue Tree, the chart data was accurate.

Why is it a scale of 8?
You do not have the required permissions to view the files attached to this post.
 
Devil
Member Candidate
Member Candidate
Posts: 170
Joined: Thu Jul 21, 2011 9:13 am

Re: Bandwidth Monitor for Queue Tree

Thu Apr 26, 2012 1:26 pm

Could it be that those values are in bits and by multiplying them by 8, you're just making them in bytes?
 
User avatar
chechito
Forum Guru
Forum Guru
Posts: 2990
Joined: Sun Aug 24, 2014 3:14 am
Location: Bogota Colombia
Contact:

Re: Bandwidth Monitor for Queue Tree

Wed Feb 19, 2020 8:39 pm

yes that values are in Bytes

actually there is a 64bit additional value available

Who is online

Users browsing this forum: No registered users and 14 guests