Refresh script values

mbahram · Sat Feb 17, 2018 11:30 am

Hello,

I wrote a script that gets important values (signal, SNR, CCQ, rates, MAC, IP) from all the connected clients on the AP.

script.jpg

Can I make this script run every specific interval such that it only refreshes those values just how

/interface wireless monitor wlan1

works ?

inwimowl.jpg

mbahram · Wed Feb 28, 2018 10:50 am

Any one ?

sebastia · Thu Mar 01, 2018 10:18 pm

Are you just after scheduling of the script? have a look at /system scheduler.
https://wiki.mikrotik.com/wiki/Manual:System/Scheduler

mbahram · Mon Mar 05, 2018 9:53 am

Are you just after scheduling of the script? have a look at /system scheduler.
https://wiki.mikrotik.com/wiki/Manual:System/Scheduler

Not exactly, what I need is to keep the values refreshing when I call the script with

/sys scr run scr_name

and stop it with