Hi guys,
simple question:
RB with 4 interface UP. eth1, eth2, eth3 and eth4
eth1 is a WAN for me, configured as PPPoE-Client with add default default route=no
eth2 is similiar, but with another carrier
eth3 is LAN1 192.168.1.1/24
eth4 is LAN2 192.168.2.1/24
i modify PPPoE distance, 10 for my WAN1, 20 for WAN2 (to stay safe)
dual mark-routing
chain prerouting src-address 192.168.1.0/24 action mark-routing lan1
chain prerouting src-address 192.168.2.0/24 action mark-routing lan2
and last i added 2 route
dst-addr=0.0.0.0 gateway=pppoe-out1 routing-mark=lan1
dst-addr=0.0.0.0 gateway=pppoe-out2 routing-mark=lan2
(all charapters "=/*" and other are not mentioned here.... wrote this post just as i remember)
my rules doesn't work... every connection, pass only on a single WAN
P.S. even in past i had some issue with PPPoE-client mode (instead using IP Addresses in all rules and routes)
how could I solve?