Page 1 of 1

How To choose The Best Channel ??

Posted: Wed Nov 14, 2007 6:14 pm
by karo84
Hi Every one
I have written a script to choose the channel which noise-floor is lower, but it seems it doesn,t work well
Look at My script what parameter can I choose to have the Best channel ??
:foreach i in=[/interface wireless find mode=ap-bridge] do={/interface wireless monitor $i once do={:if ($noise-floor > -98) do={:local tmpfreq [/interface wireless get $i frequency ];
:log error $tmpfreq ;
:set tmpfreq ($tmpfreq + 5);
:log warning $tmpfreq;
:if ($tmpfreq < 2472) do={/interface wireless set $i frequency=$tmpfreq} else={/interface wireless set $i frequency=2412 ;}}}}

Re: How To choose The Best Channel ??

Posted: Tue Nov 27, 2007 10:56 am
by leonj
is this in client side or in AP side?

Regards
Leon

Re: How To choose The Best Channel ??

Posted: Tue Nov 27, 2007 12:52 pm
by karo84
Of course on Access Point's Side

Re: How To choose The Best Channel ??

Posted: Tue Nov 27, 2007 2:49 pm
by mrz
Is it on 2.9 or 3.0 ?

Re: How To choose The Best Channel ??

Posted: Tue Nov 27, 2007 3:05 pm
by karo84
It is on 2.9.49

Re: How To choose The Best Channel ??

Posted: Tue Dec 25, 2007 6:24 am
by sten
notice how noise-floor changes between each time you reset/reconfigure a wireless interface.