Community discussions

MikroTik App
 
kjagus
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 74
Joined: Sun Jan 30, 2005 11:29 pm
Location: Poland

Internet Connection Sharing blocking - how to?

Sat Jan 14, 2006 2:29 pm

Hi!
I try to block connection sharing for users from one of th hotspot user profile.
I try to set outgoing-packet-mark in specified hotspot user profile
 2   name="BASIC" keepalive-timeout=10m status-autorefresh=1m 
     shared-users=unlimited rate-limit="32k/256k" incoming-filter="no-p2p" 
     outgoing-filter="no-p2p" incoming-packet-mark="ttl" 
     outgoing-packet-mark="ttl" transparent-proxy=yes open-status-page=always 
     advertise=no 
and then set ttl value in mangle rule based on the packet mark set in hotspot.
 0   chain=postrouting out-interface==Klienci-bridge packet-mark=ttl 
     action=change-ttl new-ttl=set:2
But there is no one packet in mangle rule statistics - it seems most likely packets are not marked - so ANY rule based on mark have nothing to do.
Is there any good way to avoid Internet sharing for specified (by hotspot profile) user?

thanks and regards!
kjagus
 
tiagom
just joined
Posts: 21
Joined: Thu Jun 30, 2005 3:48 pm
Location: Ariquemes - Rondonia - Brasil
Contact:

Sat Jan 21, 2006 9:24 pm

it obtained to function the blockade of sharing of the customers?
 
User avatar
maroon
Member Candidate
Member Candidate
Posts: 230
Joined: Thu Oct 07, 2004 11:15 am
Location: Lebanon
Contact:

Fri Mar 10, 2006 5:46 pm

we already discussed this issue, no way to block the sharing connection. try to limit the sessions...it will do 60% of the job.

better than nothing
 
magnavox
Member
Member
Posts: 357
Joined: Thu Jun 14, 2007 1:03 pm

Re: Internet Connection Sharing blocking - how to?

Fri Oct 23, 2009 10:42 am

Have you tried to change TTL form MT to PC TTL=1? :D
 
User avatar
chapex
Member Candidate
Member Candidate
Posts: 138
Joined: Wed May 30, 2007 1:23 am
Location: Patagónia Argentina
Contact:

Re: Internet Connection Sharing blocking - how to?

Fri Oct 23, 2009 7:45 pm

Have you tried to change TTL form MT to PC TTL=1? :D
nice!

Who is online

Users browsing this forum: No registered users and 24 guests