Dear All,
I'm trying to use CRS326-24G-2S+ (revision2, RouterOS v6.48.4 level 5) as a switch for my servers.
So far everything works fine but I'd like to use eth9-eth12 as a router "within" a switch (IPMI management interfaces, intended to be available through single IP.
So in detail, a current (working) configuration is:
eth1-eth20 bound with a bridge (Bridge1), and eth21-eth24 is an "uplink" to the core network using a bonding (Bonding1) 802.1ad (LACP), also added to the Bridge1.
I'd like, however, to exclude 4 eth ports, i.e. eth9-eth12, and set up a subnetwork using them (192.168.1.0/24) then route them to the aforementioned Bonding1.
First of all - is it possible to use "part" of the switching device as a router?
And the second question is, how do I set a master interface for routing eth9-eth12 to use Bonding1, or in other words, how to construct another bridge in this configuration?
Routing performance is meaningless in this case to me as those interfaces are to be used for monitoring/IPMI only.
Thanks in advance for any hints on how to construct the router part.
Regards,
Piotr