We had a power outage last night. Power was restored after a few hours.
My RB750Gr3 was on an APC battery backup/surge protector.
It came back up but failed to work.
Port light is blinking (indicating traffic), but it's not functioning and I am unable to connect.
Can't connect via Winbox, SSH, ping, etc.
Wireshark shows no traffic from it.
Tried to reset using multiple methods found from googling:
1) Insert power connector, press reset button and release
2) Press reset button and holt while inserting power connector, then release upon solid USR light
3) Same as #2 but release only after solid USR light starts to blink
4) Same as #3 but release only after USR light turns solid again
Nothing.
Anything else I can try?
Thanks!