Dear Experts,
I am currently testing a portion of my network with version 7 due to the increasing prevalence of preinstalled routers with this software. However, I have encountered an issue with TE functionality. While I was able to create interfaces with TE in version 6 and successfully route traffic to the destination IP, I have been unable to locate the TE interface in version 7.9.2. I attempted to create a tunnel, but was unable to configure an IP address. If I were to use VPLS, I am unsure how to route traffic to the destination without bridging interfaces on the destination router.
TE: 10.10.0.1 ------------------------------ TE 10.10.0.2
R1 ====== R2 ======== R3 ========= R5
ver 6
R1, Route 192.1.1.0/24 via TE 10.10.0.2
I attempted to research the forum but found limited information. Recently, I upgraded a router that was responsible for TE and the interfaces became unknown.
Thank you,