Hello all,
I just purchased a MKT sxtsq 5ac with the hope of harnessing a LinkNYC Free / Private from a kiosk directly below my apartment. It's been slow going but thanks to this thread I now have a connection to the free version (I had exactly the same "Gateway: 10.64.0.1 unreachable" problem, solved by changing it to 100.64.0.1.) Without even a direct aim at the kiosk (which is possible) I'm getting a speed of 68.6/70.8 mbps. However connection to the private version of the kiosk is still tharting my attempts. When scanning signals I find the strongest private signal, but after clicking "connect" it requires a password. If I manually enter the password shown in the script below, it accepts it, but then hangs with the message "connecting to network". Is it a password problem or is it timing out?. Connecting to the free version is immediate (it then displays "connected to ess"). The config I'm using is the three-line code provided on the nymesh site...
/interface wireless security-profiles
add authentication-types=wpa-eap,wpa2-eap eap-methods=eap-ttls-mschapv2 group-ciphers=tkip,aes-ccm mode=dynamic-keys mschapv2-password=5fsOpxER mschapv2-username=
anonymous@citybridge.com name=linknyc supplicant-identity=
anonymous@citybridge.com tls-mode=dont-verify-certificate unicast-ciphers=tkip,aes-ccm
/interface wireless
set [ find default-name=wlan1 ] band=5ghz-a/n/ac channel-width=20/40/80mhz-Ceee country="united states2" default-authentication=no disabled=no frequency=auto security-profile=linknyc ssid="LinkNYC Private" wireless-protocol=802.11
/interface wireless connect-list
add interface=wlan1 security-profile=linknyc ssid="LinkNYC Private" wireless-protocol=802.11
Thank you in advance for any tips you can provide.