Hello, I'm new to this forum, but quite a long time user of MT products (not an expert though).
I have to set up a network connection between 2 buildings - approx 150m direct visibility. Nothing fancy, just AP and CPE router. It works, but I wonder why the data rate is rather slow. The AP ethernet side is measuring stable 90 Mbit/sec, when connecting to AP wlan it is about 40 Mbit/sec, but on the CPE side it is just below 30 Mbit/sec. The spec sheet says the rate can be as high as 150 Mbit/s (Wi-Fi G4). I did scan the area, set a free channel for the AP, antenna is omni 5GHz with 5 dB gain, so I specified it wlan config. Channel is set to 20 MHz band. Anything else I could try?
TIA, Einars