Hi,
We have 3 WAN's from 3 ISP's on ether1, ether2 and ether3.

We would like to test all of them every 30 minutes of the day per 10 seconds (send and receive).

If any of them deliver below 20 Mbps performance than the interface need to be disabled.

After 1 hour the interface goes online again and do a new test, and repeat the same situation.

All 3 links have 600 Mbps each.

Reports need to be send by email to a mailbox speedtest@ourcompany.com (example).

Is there anyone that could help with the script?

(The objective is to allow only internet access with good speed to run due to be using ECMP same path cost).

Thanks!
Rodrigo Morejon