Factory Fresh Wireless Wire Cube Pro.

Connected to a Ubiquiti Edge Switch... switch powers on the FAR CUBE. The FAR CUBE links up back to the NEAR CUBE. But no traffic gets through.

I added a DHCP client on both Wireless Wire Cube Pros and stepped them through all the updates. 7.14.2
Still doing the same thing.

Hard reset both sides. After boot up they connected again. Same issue. I see a few burps then its like the switch is blocking or being blocked.

The reason I think its being blocked, is the switch connected long enough to pull an IP address from the router on the NEAR SIDE.

Went into the FAR CUBE and set the Bridge to NO SPANNING TREE.
Set the NEAR CUBE to NO SPANNING TREE.

Traffic passed to the switch immediately.

That's weird... so much for point and shoot!!!

(I noticed something about a port already in slave on the NEAR CUBE. Need to get a pair on my desk.)