Hi,

I am looking to use winbox or telnet on Eth1/PoE on an RB450G. I am hoping to connect by MAC Address, of which it is not being listed in WinBox. Telnet does not connect either. It works on the other four ports without a problem. The following thread appears relevant, and I did remove the rule (tried disabling first) without success, so I am guessing I have another issue preventing me from being able to connect.

http://forum.mikrotik.com/viewtopic.php ... inbox+eth1

Any ideas would be much appreciated.

Hard to say without seeing your configuration but if I was you I would disable all firewall rules and try again to see if that is where your problem lies.