Hello Folks,
I am using a CRS305-1G-4S+ device running in SwitchOS mode. I am trying to create one VLAN and assign it VLAN 300. I then want to assign SFP 1 and SFP 2 to this VLAN. Under the VLAN tab, I have both SFP 1 and SFP 2 set to optional , any , 300, and ForceVLAN ID enabled. Under the VLANs tab, I have 300, port isolation, learning, and have members SFP1 and SFP2 checked. For some reason why I go to remote hosts that are connected to SFP1 and SFP 2 nothing traffic seems to pass through. Am I missing something? This used to work, but the last thing I remember is rebooting this device and then everything stopped working. Any one have any thing I can try to allow these two machines on the same VLAN communicate with each other?