Hello once again fellow MikroTikers,
to tune my home wife i bought a cAP-2nD and a Omnitik 5 PoE ac.
I am trying to of avoid a new long ethernet cable for the Omnitik 5. That is why i want to put the Omnitik behind the 2nd ethernet port of the cAP.
The cAP works fine but i cannot connect to the internet when i am connected to the Omnitik 5.
Both accesspoints are having the 192.168.88.1 IP, when i try to change it i cant connect to the accesspoint again and i need to reset the device.
To solve this i have 3 questions.
1. How do i access the webfig for a Mikrotik device from the same LAN without being directly connected via wifi.
2. How do i change the IP adress from atleast one accesspoint to avoid having the same ip twice?
3. What is most likely the configuration i missed during the setup?
Attached you can find the config for the cAP.
Solving question 1 would speed up troubleshooting for me by a lot
Best regards and thanks in advance