i want to make one local user go through specific wan IP address.i believe that config will work.
it worked but i want to know is there any problem with it.
NOTE: im a new baby in mikrotik world.
This the updated settings:
IP> Address List
Code: Select all
# ADDRESS NETWORK INTERFACE
0 ;;; defconf
192.168.4.1/24 192.168.4.0 bridge_Lan
1 ;;; AIT_WAN
10.151.000.14/30 10.151.000.12 ether1
2 ;;; Routed Block
118.179.000.73/29 118.179.000.72 bridge_Lan
Routed ip address block is something the isp give me. they have set point to point ip first to connect radio devices together. and then uses ip> route like below.
IP> Route
Code: Select all
# DST-ADDRESS PREF-SRC GATEWAY DISTANCE
0 A S 0.0.0.0/0 10.151.000.13 1
1 ADC 10.151.000.12/30 10.151.000.14 ether1 0
2 ADC 118.179.000.72/29 118.179.000.73 bridge_Lan 0
3 ADC 192.168.4.0/24 192.168.4.1 bridge_Lan 0
IP> Firewall>NAT
Code: Select all
chain=srcnat action=src-nat to-addresses=118.179.000.76 src-address=192.168.4.214 log=no log-prefix=""
chain=srcnat action=src-nat to-addresses=118.179.000.74 log=no log-prefix=""
chain=dstnat action=dst-nat to-addresses=192.168.4.208 to-ports=443 protocol=tcp dst-address=118.179.000.78 dst-port=443 log=no log-prefix=""
chain=dstnat action=dst-nat to-addresses=192.168.4.208 to-ports=80 protocol=tcp dst-address=118.179.000.78 dst-port=80 log=no log-prefix=""