Hello everyone!
I'm using Mikrotik routers couple years now, mostly for Wireless networks.
Its the first time that i want to connect a Mikrotik Managed switch with a managed Cisco Switch through a Trunk port and im having lots of trouble.
For Cisco is easy to configure but i cant say the same for Mikrotik.
I will explain my situation in detail with some screenshots and if you can please give me a hand..!
so here is the Cisco Interface in which i connected the Mikrotik:
simple stuff.
So on that interface i have connected my Eth1 Mikrotik Interface,
created the VLANS, added the to ports, created a Bridge port, added the Physical Port.
Then i assigned 2 IP addresses 1 for the Physical port in VLAN1 (which is the Native at Cisco) and 1 at port VLAN2 which have vlan ID:2
I checked that i can ping both IP's, so my trunk works (i guess).
Then i want to assign different VLANs in the other switch ports, splitting them 4 ports for VLAN1 and the rest 4 for VLAN2 = Eth1,2,3,4 for VLAN1 and Eth5,6,7,8 for VLAN2.
I didn't succeed on that.... and also i have a Windows Server with DHCP service running with IP 192.168.1.8.
My DHCP is enabled only for VLAN2. I tried to set up the DHCP relay for the VLAN2 interface but it didnt worked...
I will place some photos from my configuration to realize better what im talking about so ... im open to any suggestions and help!
The interfaces
The VLANS
VLAN2
Bridge Interface
Bridge Port Connection
Here this is a test... dont know if this works, added the VLAN ID's in Switch
I set the Egress VLAN marking
The IP assignment
The DHCP relay test i tried...