Hi
I am new to MikroTik Products and have a MikroTik RB4011 Router and CSS326-24G-2S+RM
This is the config I have on the RB4011
Ethernet Port 1 is my WAN Port
Step 1: Create Bridge
/interface bridge
add name=bridge1 vlan-filtering=yes
Step 2: Create VLAN-Interfaces
/interface vlan
add comment="LAN" interface=bridge1 name=bridge1_vlan100 vlan-id=100
add comment="Guest Wifi" interface=bridge1 name=bridge1_vlan110 vlan-id=110
add comment="Server" interface=bridge1 name=bridge1_vlan200 vlan-id=200
Step 3: Assign IP-Addresses on Interfaces
/ip address
add address=10.8.100.254/24 comment="LAN (vlan100)" interface=bridge1_vlan100 network=10.8.100.0
add address=10.8.110.254/24 comment="Guest Wifi (vlan110)" interface=bridge1_vlan110 network=10.8.110.0
add address=10.200.0.254/24 comment="Server (vlan200)" interface=bridge1_vlan200 network=10.200.0.0
add address=192.168.100.254/24 comment=MGMT interface=bridge1 network=192.168.100.0
Step 4: Create DHCP-Server
/ip dhcp-server
add address-pool=dhcp_pool0 disabled=no interface=bridge1 name=dhcp1
add address-pool=dhcp_pool1 disabled=no interface=bridge1_vlan100 name=dhcp2
add address-pool=dhcp_pool2 disabled=no interface=bridge1_vlan110 name=dhcp3
add address-pool=dhcp_pool3 disabled=no interface=bridge1_vlan200 name=dhcp4
/ip dhcp-server network
add address=10.8.100.0/24 dns-server=10.8.100.254 gateway=10.8.100.254
add address=10.8.110.0/24 dns-server=10.8.110.254 gateway=10.8.110.254
add address=10.200.0.0/24 dns-server=10.200.0.254 gateway=10.200.0.254
add address=192.168.100.0/24 dns-server=192.168.100.254 gateway=192.168.100.254
Step 5: Bridge VLAN-Filtering
/interface bridge vlan
add bridge=bridge1 tagged=bridge1,ether6,ether7,ether8,ether9,ether10 vlan-ids=100
add bridge=bridge1 tagged=bridge1,ether6,ether7,ether8,ether9,ether10 vlan-ids=110
add bridge=bridge1 tagged=bridge1,ether6,ether7,ether8,ether9,ether10 vlan-ids=200
Step 6: Assign Interface to Bridge
/interface bridge port
add bridge=bridge1 interface=ether6
add bridge=bridge1 interface=ether7
add bridge=bridge1 interface=ether8
add bridge=bridge1 interface=ether9
add bridge=bridge1 interface=ether10
Port 9 on the RB4011 I have have the CSS326-24G-2S+RM connected to Port 24
How do I configure an Access Port and a Trunk Port on the CSS326-24G-2S+RM as I am not sure of the settings to configure the VLANs on the CSS326-24G-2S+RM
Regards
Matthew