i have a working setup – but besides to never touch a running system – i wanted to setup a proper network with VLAN for private/guest/management as described in the thread
viewtopic.php?t=143620#p706997
schema is as following:
Cablemodem -> HeXs -> CRS318-NetP16 -> Patchpanel
So i started with the switch, entering every command as writen in the switch.rsc.
Yes, i started with /system reset-configuration
but as soon as i entered the last command
Code: Select all
#######################################
# Turn on VLAN mode
#######################################
/interface bridge set BR1 vlan-filtering=yes
Okay, so i thought maybe i have to configure the router to get it working, but i hit the same state:
After entering the last command
Code: Select all
#######################################
# Turn on VLAN mode
#######################################
/interface bridge set BR1 vlan-filtering=yes
okay. bad.
I reseted everything and started with the router.
Same result. Kicked out. I don't see the device and don't get an IP via dhcp.
Went directly to the Router and plugged in a cable in a free port.
Nothing. I don't see the device and don't get an IP via dhcp.
I reduced the example to ONE Vlan --> nothing. I don't see the device and don't get an IP via dhcp.
Some hours later i reverted to the old configuration by restoring the backup. So now i'm here again and clueless as never before.
I thought i read AND understood the example, but i am missing something and i don't get it.
I thought this was an working example, or do i have to alter something to get it working?
I just don't know what i did wrong and feel a little stupid :\
Any hints? thank yo