I meant configuration of wireless interfaces, not configuration in general. All wireless interface configuration is done on CAPsMAN, not on individual CAPs
On my CAPsMAN I configured channel (`/caps-man channel`) to be `2ghz-onlyn`. I then added a CAP interface (`/caps-man interface`) for a different AP. While this results in CAP interface being propagated onto that AP, the channel options are not applied which I verified via `/interface wireless print` on that AP:
CAPsMAN:
/caps-man interface print detail
name="..." mac-address=... arp-timeout=auto
radio-mac=... master-interface=none
radio-name="..." configuration=Matryoshka 2.4Ghz
security=Matryoshka datapath=Matryoshka mtu=1500 l2mtu=1600 arp=enabled
channel=Matryoshka 2.4Ghz channel.tx-power=20
current-state="running-ap" current-channel="2427/20-Ce/gn(20dBm)"
current-rate-set="CCK:1-11 OFDM:6-54 BW:1x-2x SGI:1x-2x HT:0-15"
current-basic-rate-set="OFDM:6 BW:1x HT:0-7"
current-registered-clients=4 current-authorized-clients=4
/caps-man configuration print detail
name="Matryoshka 2.4Ghz" mode=ap ssid="Matryoshka" country=united states3
installation=any disconnect-timeout=10s security=Matryoshka
datapath=Matryoshka channel=Matryoshka 2.4Ghz
/caps-man channel print detail
name="Matryoshka 2.4Ghz" control-channel-width=20mhz band=2ghz-onlyn
extension-channel=XX reselect-interval=1h skip-dfs-channels=no
CAP:
/interface wireless print
;;; managed by CAPsMAN
;;; channel: 2427/20-Ce/gn(20dBm), SSID: Matryoshka, local forwarding
name="wlan1" mtu=1500 l2mtu=1600 mac-address=...
arp=enabled interface-type=Atheros AR9300 mode=ap-bridge
ssid="MikroTik-3790B5" frequency=auto band=2ghz-b/g/n
channel-width=20/40mhz-Ce secondary-frequency="" scan-list=default
wireless-protocol=802.11 vlan-mode=no-tag vlan-id=1 wds-mode=disabled
wds-default-bridge=none wds-ignore-ssid=no bridge-mode=enabled
default-authentication=yes default-forwarding=yes default-ap-tx-limit=0
default-client-tx-limit=0 hide-ssid=no security-profile=default
compression=no
Do I understand correctly that most of the data printed on CAP is noise and is not actually used?