I am trying to config OmniTIK G-5HacD to serve as a dynamic wifi extender which can bridge (not sure if this is the right term) to another router from both ethernet or wifi.
I have 2 types of physical setups which I would like to support with the same configuration for the OmniTIK G-5HacD.
In both scenarios I have another RouterOS device which serve as a wifi access point with ssid=test-1
My goal is that my OmniTIK device will serve as an extender with ssid=test-2. But it should support 2 scenarios:
1. It is conected to the first router via wifi
2. It is conected to the first router via ethernet (in this scenario the OmniTIK can't see the first router ssid)
I was able to create a configuration for scenario 1, where my master wifi interface wlan1 is in `mode=station-bridge` and I have another virtual wifi interface wlan2 in `mode=ap-bridge`
I was also able to create a configuration for scenario 2, where my master wifi interface wlan1 is in `mode=ap-bridge` and wlan1 is also part of a bridge interface with all the other ethernet interfaces.
I wasn't able to create a single config where I can install in both setups, and it will bridge (again not sure that this is the right term) to the first router.
How can I achieve this kind of config?
Is this type of config even possible in RouterOS?
Any help would be appreciated.