Wed Jan 26, 2022 8:54 pm
Well, got the kit, but I can't seem to make it work. There is a connection, but it seems to be one-way. RB5009 is TX but not RX; while the CRS328 is RX but not TX. I've tried with auto-negotiation on/off, different speeds, but it's only one-way. RB5009 shows status as Enabled / Running / Slave / Link OK / Auto-Negotiation Incomplete / Rate 10G / Full Duplex. CRS328 shows Enabled / Running / Link OK / Auto-Negotiation Done / Rate 10G / Full Duplex. I've tried switching the cable around, switching the transceivers around, rebooting both devices. Same results every time.
Are there settings that I've missed? Do I have faulty equipment? Switching the transceivers around would seem to eliminate them, right? Maybe bad cable? More likely, I've done something wrong or not done something that I should have....