Hi, MikroTik. I post it back again.
I'm CCR1009-7G-1S-1C+PC User.
But this router have very big problems.
Because, The Router CPU Temperature over 60'c hit router's WAN port not received IP.
This is very big problem. Yesterday, The Router is over heat,
I rebooting Router then router was lost IP. I very nervous. And have much uneasy.
I was using Synology NAS with this router. I work with NAS my job.
Outside NAS not access, i many big problem.
Your do upgrade firmware and can solving this? I already received RMA last month.
I think, RMA twice is not mean. Two router have same problems.
And RMA cost is very expancive. example, money, time, etc.
If ether1(Wan) Port is swiched 100M half, Router ip received but very slow.
When wording detail, Router is start low temperature to high temperature.
But this situation (low to high) has the router's CPU temperature overheat over 60'C, the router received ip.
However when I 'reboot' or 'disable port from interface option' in the current situation,
The router can not get ip. Of course, 'disable port' next 'enable'.
To receive the ip again, the router needs to cool down under 60'C and power off.
It has many problems, because inevitable shutdown. example, blackout, firmware upgrade and other rebooting.
Any time when over 60'C overheat and rebooting, I can't router cool down under 60'C and power off every time.
Especially when I am outside the house. I can not cool down (shutdown) the router directly.
I want to hear this solutions to problems.
I was had other MikroTik Switch and Router have not problem.
Even, CRS326 default temerature is about 80'C.
'hAP AC' is works well to more extreme situations
Another problem not occured.
What about the other CCR1009-7G-1S-1C + PC users? Are you have same problem?
I wait solving perfect.
Thanks a lot.