Hi everyone
I have a CS326 wit SwOS 2.13 running. I got a new motherboard that should support 2.5 Gbit. The auto negotiation puts it on 1GBit. I will have to make sure kubuntu actually supports 2.5 GBit in the first place but just so I don't waste my time I wanted to ask whether the switch even supported this.
When I turn off Auto Negotiation, 2.5 isn't offered as a fixed speed so I'm unsure.
Edit: Just checked on linux:
Settings for enp38s0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
2500baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
2500baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Link partner advertised pause frame use: Transmit-only
Link partner advertised auto-negotiation: Yes
Link partner advertised FEC modes: Not reported
Speed: 1000Mb/s
Duplex: Full
Auto-negotiation: on
master-slave cfg: preferred slave
master-slave status: slave
Port: Twisted Pair
PHYAD: 0
Transceiver: external
MDI-X: Unknown
netlink error: Operation not permitted
Link detected: yes
So the switch does not advertise 2.5Gbit. therefore no auto negotiation... so I'm guessing unsupported?