How can I figure out the root cause of the disconnection? Signal is great always over 90%.
Device that are connected are mostly a few windows laptops and mobile phones. Disconnecting time is just random.
Is it possible to enable some kind of debug mode so I can see the disconnect reason on the device?
Any recommendation to change WiFi settings so it will perform better (or it is just a limitation of the device too slow/too cheap?).
Current simple configuration. Yes I have setup the country code just removed from screenshot.
Here is my configuration it's very simple (removed country, ssid, device name from post but it's configured on the device)
Code: Select all
# may/02/2022 by RouterOS 7.2.2
# software id = 7QGY-T6VT
#
# model = 951-2n
# serial number =
/interface bridge
add name=bridge1
/interface wireless
set [ find default-name=wlan1 ] antenna-gain=1 band=2ghz-g/n country= \
disabled=no frequency=auto installation=indoor mode=ap-bridge ssid= \
wireless-protocol=802.11 wps-mode=disabled
/interface list
add name=WAN
add name=LAN
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa-psk,wpa2-psk group-ciphers=\
tkip,aes-ccm mode=dynamic-keys supplicant-identity=MikroTik \
unicast-ciphers=tkip,aes-ccm
/interface bridge port
add bridge=bridge1 interface=ether2
add bridge=bridge1 interface=ether3
add bridge=bridge1 interface=ether4
add bridge=bridge1 interface=ether5
add bridge=bridge1 interface=wlan1
/ipv6 settings
set disable-ipv6=yes
/interface list member
add interface=ether1 list=WAN
add list=LAN
add interface=bridge1 list=LAN
/interface ovpn-server server
set auth=sha1,md5
/ip address
add address=192.168.1.5/24 interface=bridge1 network=192.168.1.0
add address=192.168.1.4/24 interface=ether1 network=192.168.1.0
/ip dhcp-client
add disabled=yes interface=ether1
/ip dns
set servers=1.1.1.1,1.0.0.1
/ip service
set telnet disabled=yes
set ftp disabled=yes
set www disabled=yes
set ssh disabled=yes
set api disabled=yes
set api-ssl disabled=yes
/ip upnp
set enabled=yes
/ip upnp interfaces
add interface=bridge1 type=internal
add interface=ether1 type=external
/system clock
set time-zone-name=
/system identity
set name=
/system leds
set 0 disabled=yes
/system routerboard settings
set auto-upgrade=yes