When I was on 6.49.2 this config as documented at https://wiki.mikrotik.com/wiki/Manual:VLANs_on_Wireless worked just fine:
/interface bridge
add name=bridge1 vlan-filtering=yes
/interface vlan
add interface=bridge1 name=lan vlan-id=10
/interface wireless
set mode=ap-bridge name=wlan1 security-profile=wlan1 ssid=wlan1 station-roaming=enabled vlan-id=10 vlan-mode=use-tag wireless-protocol=802.11
/interface bridge port
add bridge=bridge1 interface=wlan1
/interface bridge vlan
add bridge=bridge1 tagged=bridge1,ether2,wlan1 vlan-ids=10 untagged=ether3
After upgrading to 7.2.3 it simply wouldn't bridge the wireless interface and I had to resort to removing the vlan-mode=use-tag in the wireless interface and put it in the bridge vlan untagged:
/interface bridge
add name=bridge1 vlan-filtering=yes
/interface vlan
add interface=bridge1 name=lan vlan-id=10
/interface wireless
set mode=ap-bridge name=wlan1 security-profile=wlan1 ssid=wlan1 station-roaming=enabled wireless-protocol=802.11
/interface bridge port
add bridge=bridge1 interface=wlan1 pvid=10
/interface bridge vlan
add bridge=bridge1 tagged=bridge1,ether2 vlan-ids=10 untagged=ether3,wlan1
Why did the first config not work in 7.2? I would think that the wifi interface tagging everything like a trunk interface should have worked fine. Did this change in 7.2?