Installed 7.3.1 with wifiwave2 package today on my hAP AC3 home router.
I think wifiwave could be a lot more intuitive than what I see now:
1. By default wifiwave interfaces names are wifi1 and wifi2. I'm not sure where is 2.4 and where is 5 GHz radio there. It is possible to select 5GHz channels on a 2.4GHz radio and 2.4GHz channels on a 5GHz radio, that's only make things more complicated.
2. Why do we need the exactly same settings (configuration, channel, security) in a both wifiwave2 interfaces and wireless tables?
3. I need to configure G/N(/AX) for a 2GHz band and N/AC(/AX) mode for a 5GHz band. There is only separate G or N and N or AC, I need them both for best performance and legacy support.
4. There is no selectable standard frequencies in the channel configuration. I could only guess - will my phone scan this frequency and connect. For example: I can type frequency 5432 MHz and my phone will not connect.
5. I have set TX Power on both interfaces to 17 dBm. In the standard wireless package we had a total TX Power table (usually ~3 dBm higher). What total TX Power will be there?