Hello.
Using winbox, i saw an update pending ( 7.4rc2)
Chose to update and install
crs305 went rebooting - verrrry long time
after reboot, the sfp+ leds 1-2-3-4 are blinking once every 40 seconds
no sfp+ link are establish with my 3 devices connected to the crs305
no winbox access via crs305 IP
winbox doesnt see any crs305 in neighbors list
conclusion, crs305 is bricked due to firmware fucked
SO
tried netinstall
tried using sfp+ but no link
tried using eth/boot with IP sets to 192.168.88.1
crs305 not seen by netinstall ( tried all netinstall version ) !
----------
I don't know what to do anymore.
This is not the first time i had issue with firmware update on this crs305.
To be honets, almost every update were funcky. Never been straight forward once !!
But i always was successful with the netinstall process.
But this time, i am stuck and bricked.
Should i consider the unit dead and switch to a more friendly pieces of hardware...
I am no beginner, but i am so fed up by this model.
IF ANYONE HAS A STEP BY STEP WAY TO UNBRICK THIS UNIT, I WOULD BE GRATEFUL...
did follow this https://wiki.mikrotik.com/wiki/Manual:Netinstall but no success !