I have a ccr2116 and we see that it never exceeds 20% of the CPU but when we go to tool then to profile we notice that cpu0 is always at 90% and the other cpu use is very low
600 PPPoE + 750MB+SINGLE QUEUE + QUEUE TREE
Could you help me
¿Can you post your config and ROS version?
It's definitely a problem. In fact, this only happens on the ARM architecture. It looks like the problem is still present even on ROS7. It occurs when PPP and NAT are on the same box. It will not multi-thread properly even when there are queues in Simple Queue. Any device that is not using ARM as its architecture should work fine. I've tested this with HexGr3, which has MMIPS and Hap AC2 with ARM architecture, using ROS v6.x. CPU 0 will always be used in ARM, while other cores are left unused. I have not yet tested this with ROS7.Ok, I do not see any problem, with 200 firewall rules and all traffic scansioned against layer7 filter (= disabling hardware offload if the cpu must check every single connection for x packets...),
600 PPPoE + 750MB + SINGLE QUEUE + QUEUE TREE
is pretty normal