Hi there,
Newb here. I'm trying to setup PPTP VPN in a lab environment to enable remote access to my network.
Upon setting up, tested local connection - VPN works.
Connecting from another network seems to fail for unknown reasons.
Pardon my absolute lack of knowledge on this.
Connecting remotely via Windows 10 yields this:
Exported config:
/ip pool
add name=dhcp_pool1 ranges=10.0.10.50-10.0.10.254
add name=PPTP_pool ranges=192.168.2.10-192.168.2.100
/ip dhcp-server
add address-pool=dhcp_pool1 disabled=no interface=bridge name=dhcp1
/ppp profile
add local-address=10.0.10.1 name=PPTP remote-address=PPTP_pool
interface bridge port
add bridge=bridge comment=defconf interface=ether3
add bridge=bridge comment=defconf interface=ether4
add bridge=bridge comment=defconf interface=ether5
add bridge=bridge comment=defconf interface=sfp1
add bridge=bridge comment=defconf interface=ether2
/interface l2tp-server server
set default-profile=PPTP ipsec-secret=####### use-ipsec=yes
/interface list member
add comment=defconf interface=bridge list=LAN
add comment=defconf interface=ether1 list=WAN
add interface=unifi list=WAN
/interface pptp-server server
set enabled=yes
/ip address
add address=10.0.10.1/24 comment=defconf interface=bridge network=10.0.10.0
/ppp secret
add name=username password=####### profile=PPTP service=pptp
Appreciate any kind assistance. Regards,
Basyir