Hi all,
I use a SADP tool to discover Hikvision CCTV cameras on my network, it operates using Multicast UDP.
This application works fine if the PC is running from is on the same VLAN as the cameras, however if the PC is on a different VLAN it can't discover them.
IP Camera is on VLAN 40 - 10.0.40.X
PC running SADP discover application is on untagged 192.168.100.X
The PC can ping and connect to the IP camera without any problems.
I've installed the multicast package, although just a bit lost on how to configure it?
- Which interface do I add it on? Bridge / Eth2 (Trunk) / VLAN_10 / VLAN20 etc... ?
- In the interface tab do I need to enter any alternative subnets?
- RP tab I just select any gateway address allocated to my router?
Appreciate any assistance.
Thanks