Community discussions

MikroTik App
 
User avatar
drasir
just joined
Topic Author
Posts: 20
Joined: Sat Sep 11, 2021 4:48 pm

RB5009UPr Eth1 LED

Fri Sep 23, 2022 6:00 pm

Hey there,

the LED on Port 1 of RB5009UPr is "blinking differently" to all other eth LEDs. With traffic present it a a steady On-Off Cycle.. All other ports do blink more in quick succession.. like Paket-Bursts.
Behaviour is like switching von "interface activity" to "interface transmit" in LED settings.
Since all ports are connected to the same switch chip, are there plans to make all leds behave the same?
 
User avatar
Znevna
Forum Guru
Forum Guru
Posts: 1122
Joined: Mon Sep 23, 2019 1:04 pm

Re: RB5009UPr Eth1 LED

Tue Sep 27, 2022 9:19 pm

Doubt it, ether1 is connected differently than the other ports.
Ether1 is provided by a QCA8081 transceiver.
MTKEK Certified, IP Sparky
Check yer peers!
 
User avatar
drasir
just joined
Topic Author
Posts: 20
Joined: Sat Sep 11, 2021 4:48 pm

Re: RB5009UPr Eth1 LED

Wed Sep 28, 2022 2:22 pm

Image

I was going with the block diagramm, there, it is not obvious.
Thanks for the input!

Who is online

Users browsing this forum: No registered users and 16 guests