Hello, when I set the port mapping according to the official manual, it has no effect. How to troubleshoot the problem? The following is the configuration content。
[admin@MikroTik] /ip firewall nat> print
Flags: X - disabled, I - invalid, D - dynamic
0 ;;; NAT
chain=srcnat action=masquerade out-interface=pppoe-out1 log=no
log-prefix=""
1 ;;; NAT
chain=srcnat action=masquerade out-interface=pppoe-out2 log=no
log-prefix=""
2 ;;; 3389
chain=dstnat action=dst-nat to-addresses=192.168.88.226 to-ports=3389
protocol=tcp in-interface=pppoe-out1 port=3389 log=no log-prefix=""
The default configuration, the two wan ports have not yet set PCC