I have two hAP ac³ routers that work flawlessly with no complains.
Now I got another pair and decided to use wifiwave2.
The problem is that signal is good only in the line of sight. As soon as there is at least one wall, the signal becomes really poor.
This is a normal house with aerated concrete walls.
When in the same room, performance is absolutely OK, iperf3 to another device in LAN shows
Code: Select all
[ ID] Interval Transfer Bitrate
[ 7] 0.00-10.00 sec 571 MBytes 479 Mbits/sec sender
[ 7] 0.00-10.02 sec 569 MBytes 476 Mbits/sec receiver
Code: Select all
[admin@ap] /interface/wifiwave2> export
# oct/23/2022 13:42:27 by RouterOS 7.6
# software id = ...
#
# model = RBD53iG-5HacD2HnD
# serial number = ...
/interface wifiwave2 channel
add band=5ghz-ac frequency=5180,5260,5500 name=ch-5ghz width=20/40/80mhz
add band=2ghz-n frequency=2432,2472 name=ch-2ghz width=20mhz
/interface wifiwave2 configuration
add country=Latvia name=IOT ssid=IOT
/interface wifiwave2 security
add authentication-types=wpa3-psk name=common-auth wps=disable
/interface wifiwave2 configuration
add country=Latvia name=common-conf security=common-auth security.ft=yes ssid="my great wifi"
/interface wifiwave2
set [ find default-name=wifi1 ] channel=ch-2ghz configuration=common-conf disabled=no
set [ find default-name=wifi2 ] channel=ch-5ghz configuration=common-conf disabled=no
add configuration.country=Latvia .mode=ap .ssid=IOT disabled=no mac-address=1A:FD:74:36:F8:EA master-interface=wifi2 name=wifi3
add configuration.country=Latvia .mode=ap .ssid=IOT disabled=no mac-address=1A:FD:74:36:F8:E9 master-interface=wifi1 name=wifi4
Appreciate your input and best regards,
Ivars