My router is RB2011 with ROS 7.6.
And I want to enable ipv6 on it, after search the internet, I do things below:
1.enable ipv6 as setting.jpg
2.define ipv6 DHCP client as dhcp client.jpg
3.define ipv6 address as address.jpg
4.define ipv6 nd as nd.jpg
After that, I can see the ipv6 address-list as address-list.jpg, but my PC connect to rb2011 without ipv6 ip address.
Then search the internet again, somebody said need disable IGMP snooping in bridge-local that I defined in address.jpg, I do it, and the ipv 6 address showed additional entry on it, and my pc will has the ipv6 ip address. see address-list-2.jpg.
But after I power off the RB2011 and power on again, the address-list-2.jpg will change back to address-list.jpg, the additional entry was gone, and the pc without ipv6 ip again!
Any suggestion about it?