I received my cAP XL ac today. It came with ROS 6.47.10, so I downloaded 6.49.2 to upgrade. After reset, no response. Bricked right out of the box! I went to Netinstall, which I've used a number of times, although it can be wonky. I've had NO success.
Is there something different about Netinstall on the cAP devices? I used ETH1, with POE injector, to my laptop, disabled the firewall, set everything up like I've always done, and I can't get this device to show up in the Netinstall window. I've tried every trick in the book - using a gigabit switch in between the device and the laptop, etc. The upgrade firmware I used was 6.49.2 ARM - I couldn't find this unit listed on the ROS download page. Is this the correct firmware?
Have I missed something here??
Help appreciated
Regards,
Dave