Before starting, I'm not an advanced user and the use cases for those devices are between home and small office, pretty basic config with a couple of VLANs configured following the wiki (help).
Weeks ago I noticed all devices from the network were unable to get the IP address, few changes of cables, port and problem was solved for me. The day after I get a call, the problem still exist, OK could be the unmanaged switch. Lucky me the device is RB4011 Wi-Fi version and devices are using wireless in the meantime.
Last weekend I spent a day yelling against a VoIP gateway unable to get the IP via DHCP, it worked the day before using a static IP, lucky me again to have a CRS326 connected to the router using a Trunk port and the specific VLAN configured to a port, worked immediately. OK is the eth5 fault, not the first time, again an RB4011 device.
In the end, I have two RB4011 devices with problems getting the IP, both configured in a similar way, ROSv7.8 and firmware update, strange.
Is anyone having a similar problem?
This is the relevant part of config:
Code: Select all
/interface bridge add name=Bridge protocol-mode=mstp frame-types=admit-only-vlan-tagged ingress-filtering=yes vlan-filtering=yes
/interface bridge port add bridge=Bridge interface=ether5 pvid=10 hw=yes
/interface bridge vlan add bridge=Bridge tagged=Bridge,sfp-sfpplus1 untagged=ether5 vlan-ids=10