I have the CRS504 (4 port 100Gbps) switch in a very simple configuration almost straight out of the box with 2 bridges:
“Mgmt”: contains just the mgmt port.
”bridge”: contains all the qsfp ports.
I noticed that I have activity on 3 of my plugged-in qsfp ports but zero traffic showing on “bridge”. I then noticed that the MAC address of both bridges is the same. I did not configure it like this and i am hesitant to make any changes as it is now in production. So a few questions:
1. Is this normal/expected?
2. Why is there zero traffic on “bridge” even though three of its ports have activity?
3. Why does Torch showing nothing on the 3 ports, even though there is activity? For example, I run a ping from one device to another and I would expect to see the icmp traffic when Torching the ports.
Thanks