Wed Apr 26, 2023 9:30 pm
And the question is ?
If you make sure the input voltage for AC1 is 57V.
On output it will give 400mA, that's give or take 20-something W.. At maximum 22.4W (not taking into account voltage drop over feeding wire)
Just enough or not for a second device with maximum power consumption of 24W.
Standard power brick for cAP AC is 24V, at 500mA output that's only 12W. Surely not enough for a device with minimum power requirement of 13W and most likely the reason why everything comes down when you try.
That second eth port was IMHO never intended for a second cAP AC.
cAP, yes. cAP Lite, yes.
cAP AC, you could be running out of luck...