May I use the hold-reset on power technique instead? When I try your way, I can't connect to the hAP anymore...1. Go to System->Reset Configuration, tick "Do Not Backup" and "No Default Configuration" then click Reset Configuration
Did you mean IP address?2. When the router has rebooted access the Quick Set page using the MAC address of the hAP
How do I know which is the appropriate netmask, gateway and DNS ? My router IP is 192.168.1.1 and provides IP in the range of 192.168.1.xxx.4. Under Bridge set a static IP in your home wifi subnet along with the appropriate netmask, gateway and DNS. Select "Bridge All LAN Ports". Make sure it is not an IP that the home router would assign automatically.
How? In Winbox, I only see a promp for IP address.6. Access the configuration pages using the MAC address
# dec/04/2019 23:20:21 by RouterOS 6.42.11 # software id = V8LI-Q6E1 # # model = RB941-2nD # serial number = A1C50A2CBA7A /interface bridge add name=bridge1 /interface wireless security-profiles set [ find default=yes ] supplicant-identity=MikroTik add authentication-types=wpa2-psk eap-methods="" management-protection=\ allowed mode=dynamic-keys name="helios medical" supplicant-identity="" \ wpa2-pre-shared-key=WIFI-PASSWORD /interface wireless set [ find default-name=wlan1 ] band=2ghz-b/g/n channel-width=20/40mhz-Ce \ disabled=no frequency=auto mode=ap-bridge security-profile=\ "helios medical" ssid="WIFI-NAME" wireless-protocol=802.11 /interface bridge port add bridge=bridge1 interface=wlan1 add bridge=bridge1 interface=ether1 add bridge=bridge1 interface=ether2 add bridge=bridge1 interface=ether3 add bridge=bridge1 interface=ether4 /ip dhcp-client add dhcp-options=hostname,clientid disabled=no interface=bridge1 /system identity set name=APxxx