Hi,
I've just setup my new metal 52 AP and HAP AC router on my boat/home.
My goal is marina internet.
I've tried several things to get the WAN set to ether5 where I have POE.
Each time I've had issues.
Bottom line is I'd like to understand how to set the router up to make ether1 a bridged port and ether5 the WAN port.
At sometime I'll get an LTE AP and I'll want both. I'm not there yet.
I saw some info on doing that but I need all the ether ports I can get for my internal wired network.
I saw some posts from W32pamela. They were promising. When I tried that config, I had to reset the groove.
Seems like I should put the groove in the most basic setup - right now it's CPE.
I would think all the work should go into the router side.
There are so many freaking options. I think I will really like this setup once I get more comfortable with it.
I've been using a bullet and cisco router.
Thanks!
Sam