[admin@MikroTik] > interface lte scan lte1
[admin@MikroTik] > interface lte set lte1 operator=($MCC-MNC)
[admin@MikroTik] > interface lte set lte1 network-mode=3g
[admin@MikroTik] > interface lte info lte1
pin-status: ok
registration-status: registered
functionality: full
manufacturer: "MikroTik"
model: "R11e-LTE6"
revision: R11e-LTE6_V020
current-operator: Plus
lac: 11009
current-cellid:
75494651
access-technology: 3G HSPA+
btsearch.pl give me info about this BTS CellID
chrome_PeDsmS0hPN.png
[admin@MikroTik] > interface lte cell-monitor lte1
PHY-CELLID BAND EARFCN RSRP RSRQ RSSI SINR
0 3030
1 3030
9 3030
11 3030
14 3030
16 3030
17 3030
18 3030
19 3030
20 3030
This EARFCN "3030" I check at
https://www.cellmapper.net/arfcn?net=UM ... 3030&MCC=0 and this is Band 8/FDD/946 MHz/5 MHz -> slow but big distance
[admin@MikroTik] > tool bandwidth-test address=[:resolve btest.domain.tld] protocol=tcp direction=both
tx-10-second-average: 531.9kbps
rx-10-second-average: 2.5Mbps
Finaly I try do Cell Lock in 3G by:
[admin@MikroTik] > interface lte at-chat lte1 input="AT*Cell=2,
1,,3030,
1-20"
output: +CME ERROR: phone failure
This UMTS_TD not work, with this EARFCN
[admin@MikroTik] > interface lte at-chat lte1 input="AT*Cell=2,
2,,3030,
1"
[admin@MikroTik] > interface lte at-chat lte1 input="AT*Cell=2,
2,,3030,
.."
[admin@MikroTik] > interface lte at-chat lte1 input="AT*Cell=2,
2,,3030,
20"
This UMTS_BW I think work with FDD.
FAILURE - I cannot register to network
I think you can only provide specific parameters like
[admin@MikroTik] > interface lte set lte1 operator=26001 allow-roaming=no band=8 network-mode=3g
You do not have the required permissions to view the files attached to this post.