Hello!

I have an issue with a temp sensor in my new CCR1009-7G-1C-1S+.
I am collecting values over SNMP every 1 minute, and almost every time received value is correct (28-31C)
But sometimes i can see a spikes over 80C, every few hours.
That spikes occur in random times, not related to CPU load.
Does somebody here have similar issue?
Is it issue of CCR1009? or maybe caused by firmware (6.44.5)?
or just my device has a some hardware defect?

I have also noticed the same behaviour on some units. Have never been able to observe it via CLI - just SNMP.