Hi!
I have a ROS v7.1ß1 test setup with CHR on qemus and I have the same issue with OSPFv2. All of my ipv4 ospf routes duplicated and inactive:
[admin@rtr1.CPE] > routing/ospf/interface-state/print
Flags: D - dynamic; V - virtual-interface
0 D address=fe80::d012:2bff:fe83:2e99%Loopback0 area=backbone6 instance-id=0 state="DR" dr=10.0.10.11 bdr=0.0.0.0
1 D address=10.0.10.11%Loopback0 area=backbone4 instance-id=0 state="DR" dr=10.0.10.11 bdr=0.0.0.0
2 D address=fe80::a00:27ff:fe00:5102%ether2 area=backbone6 instance-id=0 state="Point-to-Point"
3 D address=10.0.1.2%ether2 area=backbone4 instance-id=0 state="Point-to-Point"
[admin@rtr1.CPE] > routing/ospf/neighbor-state/print
Flags: X - disabled, I - inactive, D - dynamic
0 D address=fe80::a00:27ff:fe00:4101%ether2 router-id=10.0.10.1 state="Full"
1 D address=10.0.1.1 router-id=10.0.10.1 state="Full"
[admin@rtr1.CPE] > ip route/print detail where ospf
Flags: D - dynamic; X - disabled, I - inactive, A - active; C - connect, S - static, r - rip, b - bgp, o - ospf, d - dhcp, v - vpn, m - modem; + - ecmp
DIo dst-address=10.0.0.0/30 routing-table=main gateway=ether2 type=unicast distance=110 scope=20 target-scope=10
DIo dst-address=10.0.0.0/30 routing-table=main gateway="" type=unicast distance=110 scope=20 target-scope=10
DIo dst-address=10.0.0.4/30 routing-table=main gateway=ether2 type=unicast distance=110 scope=20 target-scope=10
DIo dst-address=10.0.0.4/30 routing-table=main gateway="" type=unicast distance=110 scope=20 target-scope=10
DIo dst-address=10.0.0.8/30 routing-table=main gateway=ether2 type=unicast distance=110 scope=20 target-scope=10
DIo dst-address=10.0.0.8/30 routing-table=main gateway="" type=unicast distance=110 scope=20 target-scope=10
DIo dst-address=10.0.0.12/30 routing-table=main gateway=ether2 type=unicast distance=110 scope=20 target-scope=10
DIo dst-address=10.0.0.12/30 routing-table=main gateway="" type=unicast distance=110 scope=20 target-scope=10
etc...
Intersting is OSPFv3 works fine:
[admin@rtr1.CPE] > ipv6/route/print detail where ospf
Flags: D - dynamic; X - disabled, I - inactive, A - active; C - connect, S - static, r - rip, b - bgp, o - ospf, d - dhcp, v - vpn, m - modem; + - ecmp
DAo dst-address=b00b::10:0:10:1 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:2 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:3 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:4 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:5 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:6 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DIo dst-address=b00b::10:0:10:11 routing-table=main gateway=Loopback0 type=unicast distance=110 scope=20 target-scope=10
DAo dst-address=b00b::10:0:10:12 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:13 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:14 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:15 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
DAo dst-address=b00b::10:0:10:16 routing-table=main gateway=fe80::a00:27ff:fe00:4101%ether2 immediate-gw=fe80::a00:27ff:fe00:4101%ether2 type=unicast distance=110 scope=20
target-scope=10
[admin@rtr1.CPE] >