Are there any particular requirements for nstreme?
We were trying to set up a p2p link as a transparent bridge. First time doing it with MT rather than some off the shelf bridge.
I wanted to get a RB/3F1 and ordered through Wind Wireless. But they do not carry the RB/3F1, and on the phone said I would just have to order the parts separately through their site.
So I bought a pair of RB/3D1, and 5G/AGP off their site. Then, when I got the routers, I upgraded the license for wireless support, and installed the cards.
This means each unit is a RouterBOARD 230, 64 MB SODIMM, 64MB flash, and a 802.11a+b+g 60 mW Wireless MiniPCI Card with the Atheros 5211A chip.
I can configure the wireless up as an AP, client, etc. but there is no nstreme tab in winbox. I also tried through the serial port, and it ignores the nstreme commands.