Hi All,

I am just getting started with the MikroTik gear, coming mainly from the Cisco world. I purchased a Routerboard RB2011UiAS-2HnD-IN WiFi router to be deployed as the gateway device to my home computer lab. The layout is roughly as follows:



The lab network switches will use the Ethernet ports on the Routerboard to connect their external / internet interfaces. I would like the Routerboard to get its upstream connectivity using its own WiFi link to connect to the existing home WiFi router.

How would I configure the MikroTik Routerboard to do this?

Thanks for any advice!!!!

hi:

Connect your device to the MikroTik wireless network › Connect to MikroTik (Winbox, SSH, telnet, IOS/Android APP) › Use a WiFi Analyzer to find channel of the public wifi– Or Background SCAN by mikrotik › Change channel of the physical wlanto match the Upstream AP› Put SSID of the Upstream WiFi in the Virtual AP– Wait for connecting
source with detail: https://mum.mikrotik.com/presentations/ ... 599323.pdf

I would personally do the following (with Winbox starting from stock configuration):
1. Connect to a LAN port of the RB2011 with cable
2. Exclude the Wi-Fi interface from the bridge - Bridge -> Ports -> Delete the Wi-Fi interface
3. Include the Ether1 interface in the bridge - Bridge - Ports -> Open ether2 -> Copy -> Change the interface in the new dialog to ether 1 -> OK
4. Adjust which is the WAN port - Interfaces -> Interface list - WAN -> wlan1
5. Connect the Wi-Fi interface as a client to the Wi-Fi network of Home WiFi router - Wireless -> WiFi interfaces -> wlan1 -> Scan -> find the WiFi network and press Connect
6. Adjust the security settings of the WiFi client - Wireless -> Security Profiles -> default -> Mode: dynamic keys; Authentication Types WPA/WPA2 PSK (or other, depending on the security settings of the Home WiFi router)
If everything is OK with the security settings the RB2011 will connect to the home router
7. Enable the DHCP client of the RB2011 on the WiFi interface - IP -> DHCP client -> Change ether1 to wlan1

If everything is OK the RB2011 will receive an IP address from the Home WiFi Router and all of the clients connected to the Ethernet ports of the RB2011 will have an access to the Internet.

Fantastic and helpful responses. Thank you guys!

@3dfx - thanks a lot for the provided steps, I was able to achieve a functional bridge from my LAN ports on a hAP mini, for the device to act as a wifi bridge to my CapAC APs WLAN.
The clients are now receiving IPs from the bridge on the default IP range 198.178.88…. even so the Wi-Fi interface is set as DHCP client.
The DHCP server runs on the bridge interface.

My issue is that clients can access the internet while connected via LAN but they are not receiving IPs from my main router (gateway).

1. how can I get the IPs assigned via the DHCP to the LAN ports (connected clients) of the main router through the Wi-Fi interface?

The setup I am on is a DSL router (gateway - DHCP) > bridged via RB960PGD > to CAPsAC (capsMan) > hAP mini (Wi-Fi bridge)

Thx in advance

Hi multypla!
If you want that the MikroTik just bridges the wireless and Ethernet interfaces you need to disable the DHCP server on the router and include the wifi interface in the bridge.
You should also remove the masquerade rule in the firewall.