Community discussions

MikroTik App
 
joshhboss
Member Candidate
Member Candidate
Topic Author
Posts: 270
Joined: Thu Aug 01, 2019 2:13 pm

MikroTik CRS317-1G-16S+RM to Cisco 2960s..Port channel?

Mon Jun 14, 2021 4:59 am

So I have a big event coming up so i needed to get myself a good core 10gig switch. so i got myself the CRS317-1G-16S+RM, but the majority of the edge switches were all going to be 2960s that are mainly 1 gig. and there is probably going a few switches connecting off some of these edge switches.. so i was wondering if i should port channel or lag or really whatever would be supported by the mikrotik. i normally enter commmands like these when im doing a port channel between two switches.

port channel
#default interfaces
interface range "interfaces"
channel-group mode 1 active
then
interface port-channel 1
switchport mode trunk

I was wondering if with these commands ill be able to configure the mikrotik switch in sw0s to aggregate to the cisco. Ive looked at some videos where things like this can happen in routeros but in all honestly i do have the time to master router os. switchos looks like itll suit my needs just fine.

Who is online

Users browsing this forum: No registered users and 11 guests