Community discussions

MikroTik App
 
mdetko
just joined
Topic Author
Posts: 1
Joined: Sat Aug 28, 2021 3:52 pm

Wireless Wire Dish only Power led lights

Sat Aug 28, 2021 4:10 pm

Hi

this is my first installation and when I connect dishes, on both are only 1 led light - power.
i try to move dishes and no other LED become active.

I did not use the aim tool!
the length is about 200m and good visibility.

when I try to connect via winbox, I did not see any other device.
tried this from both sides.
Admin dish was connected to router and also disconected.
on PC I set static IP 192.168.88.1
link to photo of instalation
https://ibb.co/DM4fmF2
 
Rugx
Member Candidate
Member Candidate
Posts: 123
Joined: Thu Jan 02, 2020 1:44 pm

Re: Wireless Wire Dish only Power led lights

Thu Sep 02, 2021 10:46 am

Check if they link in close proximity <10m. If not, best would be to contact MikroTik support with supout.rif files provided
 
velk1001
Frequent Visitor
Frequent Visitor
Posts: 88
Joined: Wed Sep 23, 2020 4:01 pm

Re: Wireless Wire Dish only Power led lights

Thu Sep 02, 2021 11:11 pm

On the wireless setting Tab under Mode is one set to bridge(AP) and the client is set to station bridge?

Do a scan on the station bridge and you should see the Bridge(AP)
 
Zacharias
Forum Guru
Forum Guru
Posts: 3459
Joined: Tue Dec 12, 2017 12:58 am
Location: Greece

Re: Wireless Wire Dish only Power led lights

Thu Sep 02, 2021 11:23 pm

Normally the Power and WiFi Led should be on after the alignment...
First, check the configuration on both devices, and also make sure on the AP side the status is in Running state...
Check the logs on both devices too...

Did you made any changes to their configuration ?

Who is online

Users browsing this forum: Amazon [Bot] and 34 guests