I am attempting to play with ZeroTier on a 4011, however I simply cannot get the interface to come up.
I have installed the ZT client on my phone and successfully connected, however, I cannot get the interface to enter a running mode on my router.
I have updated the router to 7.1RC2 and installed the ZT package. I have flattened the routers configuration to ensure a simple setup.
Please see an export of the running configuration below.
Code: Select all
[admin@MikroTik] > system/routerboard/print
routerboard: yes
model: RB4011iGS+5HacQ2HnD
serial-number: A283095F8346
firmware-type: al2
factory-firmware: 6.43.3
current-firmware: 7.1rc2
upgrade-firmware: 7.1rc2
[admin@MikroTik] > export
# sep/05/2021 18:08:19 by RouterOS 7.1rc2
# software id = NRXU-LQH3
#
# model = RB4011iGS+5HacQ2HnD
# serial number = A283095F8346
/zerotier
set zt1 comment="ZeroTier Central controller - https://my.zerotier.com/" identity="EDITED" name=zt1 port=9993
/zerotier interface
add disabled=no instance=zt1 name=zerotier1 network=12ac4a1e7136e880
/ip dhcp-client
add interface=ether1
/ip firewall filter
# zerotier1 not ready
add action=accept chain=forward in-interface=zerotier1
# zerotier1 not ready
add action=accept chain=input in-interface=zerotier1
add action=accept chain=input dst-address=127.0.0.1
/ip firewall nat
add action=masquerade chain=srcnat
/ip firewall service-port
set ftp disabled=yes
set tftp disabled=yes
set irc disabled=yes
set h323 disabled=yes
set sip disabled=yes
set pptp disabled=yes
set udplite disabled=yes
set dccp disabled=yes
set sctp disabled=yes
[admin@MikroTik] > /zerotier/interface/print detail
Flags: D - dynamic, X - disabled; R - running
0 name="zerotier1" arp-timeout=auto network="12ac4a1e7136e880" instance=zt1
[admin@MikroTik] >